beautypg.com

KMC Controls CTE–1108 User Manual

Installation guide, Dual temperature room thermostat, Mounting

background image

Installation Guide

Dual Temperature Room Thermostat

CTE –1005, 1008, 1105, 1108

Mounting

Standard:

The base unit’s mounting slots are designed to align with the
holes in a standard 2" x 4" (51x102) handy conduit box.

Use a 2" (51) deep box if using conduit.

Normal screw and anchor systems may be used on solid
walls.

Hollow wall:

1. Cut a 3-3/4" x 1-3/4" rectangular opening in the wall.

(Check if unit is horizontal or vertical before cutting)

2. Make all necessary connections

3. Insert Toggle Bolt Assembly (HMO-5001, ordered separately)

through the wall and tighten.

Care should be taken not to bend or flex the base of the
thermostat.

Required Tools

• digital voltmeter
• small phillips screwdriver
• small flatblade screwdriver

• keyhole saw

Wiring

Typically, T1 and T3 are used for cooling and T2
and T4 are used for heating. Refer to the wiring
diagram.

This manual is related to the following products: