KMC Controls BAC-8007 Installation Guide - Manual (Page 23)

S e c t i o n 3 : C h an g i n g t h e r o o m s e t p o i n t
This section covers topics for the end user in a facility.
Changing the SimplyVAV user functions with an STE-8001 or STE-8201 are
limited to changing the active setpoints in a room. The setpoints are entered
or changed using the buttons and display on the front of the sensor.
Quick start to changing setpoints
1. Press any button to begin changing
setpoints.
2. If required, enter Password 1.
3. Press the up or down buttons to
change a sepoint value.
4. Press the Set
Point
button to save the value or
advance to the next function.
To enter or change the active setpoints you may need Password 1.
Tip: Once the following procedure is started, all steps must be completed in
order.
Procedure Steps STE display
1 Starting display Start from the temperature display.
3
Changing room setpoints
SimplyVAV
Revision E 23