KMC Controls BAC-8007 Installation Guide - Manual (Page 25)

S e c t i o n 4 : C o n f i g u r i n g t h e c o n t r o l l e r s
This topics in this section are advanced topics for control technicians and
engineers.
The configuration functions that are accessible through an STE-8000 series
sensor are all of the values and settings that are entered during the
installation and commissioning of a VAV terminal unit. Typically, these
functions do not change after the installation and commissioning process.
To set up the configuration functions, you will need the following items and
information.
Details about the VAV terminal unit including the configuration for fans
and reheat.
An STE-8001 or STE-8201 to use as a configuration tool.
The building automation system plans for controllers connected to a
network.
Users may change the active heating and cooling setpoints without accessing
the configuration functions. This procedure is covered in the topic
Changing
the room setpoint on page 23 .
Note: The instructions for the configuration functions cover all of the functions that
an STE-8000 sensor can set up in the SimplyVAV series of controllers. Not all
functions are available on every model of controller.
Configuration topics
Getting started with configuration 26
Entering system temperature setpoints and limits 27
Configuring the VAV Box options 31
Set the airflow setpoints 34
Advanced options 37
Restore Application 40
SimplyVAV
Revision E 25