KMC Controls FlexStat Quick Reference Guide - Manual

FlexStat 1 Quick Reference Guide
Quick Reference Guide
DRAFT
NOTE: W
atermark is
on nonwritable DRAFT
Watermark layer
. Turn the
layer off or delete layer
to remove from the final
document.
FlexStat
Controller/Sensor/Thermostat
Contents
Navigation .......................................................1
Room Temperature Setpoint Adjustment ..........1
Main Menu and Settings ..................................2
Schedules .........................................................2
Heat/Cool, Fan, Occupancy, and Override ......2
Navigation
Navigate the menus and change settings by press-
ing a combination of various arrow buttons and the
(center round) Enter button. Push the:
• Enter button to select and/or exit value editing.
• Up or Down button to move among entries.
• Right or Left button to move among value fields.
• Left button to return to the Home screen.
NOTE: Access to various functions may require a
password.
NOTE: See the FlexStat Operation Guide for
complete details on FlexStat configuration.
Room Temperature Setpoint Adjustment
From the Home (temperature display) screen, press
the Up or Down arrow button once to view the exist-
ing setpoint.
To temporarily change the setpoint, press the Up
or Down arrow button repeatedly until the desired
setting is displayed and press Enter. (If Enter is not
pressed, the display will return to the Home screen
after about ten seconds and the new setpoint value
will still be saved.) The new setpoint will hold until
the next schedule change.
To permanently change the setpoint for occupied
mode, go to the Setpoints section under the Main
Menu. (In the Setpoints menu, heating/cooling set-
points/setbacks and deadband can be changed with,
if required, the correct password access.)
WED 9/3 5:43 PM
COOL:
OCC:
FAN:
HUM: 31%RH
MAIN MENU
ABOUT
ADVANCED
ALARM
DATE/TIME
SCHEDULE
SETPOINTS
SYSTEM
SCHEDULE
ENTIRE WEEK [MON–SUN]
WEEKDAYS [MON–FRI]
WEEKEND [SAT–SUN]
INDIVIDUAL DAYS
HOLIDAYS
ENTIRE WEEK
1:
2: 5:15:00 PM OFF
3:
4:
5:
6:
[—>] DELETES ENTRY
7:30:00 AM ON
SYSTEM MODE
SYSTEM ENABLE: AUTO
OCCUPANCY OVERRIDE
OCC OVERRIDE: OFF
FAN MODES
UNOCC:
OCC: AUTO
AUTO
Override
Setpoint Adjustment
Home Screen
Override Screens
Configur
ation
Configuration Screens
Right
(Menu)
Left
(Override)
Down (Setpoint)
Up (Setpoint)