beautypg.com

KMC Controls CTE-1101 User Manual

Installation guide, Mounting wiring

background image

CTE-1001/1002/1101

1

Installation Guide

Installation Guide

Single Setpoint Room Thermostats

CTE-1001/1002/1101

Mounting

Wiring

Refer to the diagram above for screw terminal loca-

tions.

T3 is not restricted by the minimum and maxi-

mum control points. See the diagrams on the next

page.

Typically in KMC thermostats, T1 and T3 are

used for cooling, and T2 and T4 are used for heating.

NOTE:

Only CTE-1101s have the A terminal that

is used for temperature averaging. See the

Temperature Averaging section on the next

page.

Mounting

1

Wiring

1

Temperature Averaging 1
Important Notices 2
Maintenance

2

Standard:

The base unit’s mounting slots are designed to

align with the holes in a standard 2" x 4" (51 x 102

mm) handy conduit box. Use such a box if using

conduit.

On solid walls, normal screw and anchor systems

may be used.

NOTE:

See the data sheet for a complete listing of

accessories as well as specifications.

Hollow wall:
1. Cut a 3-3/4" x 1-3/4" rectangular opening in the

wall. (Check if unit is horizontal or vertical before

cutting.)

2. Make all necessary connections.
3. Insert an HMO-5001 Toggle Bolt Assembly

(ordered separately) through the wall and tighten.

All dimensions are in inches (mm).

NOTE: Care should be taken not to bend or flex

the base of the thermostat.

This manual is related to the following products: