Getting started with configuration, Cnfg – KMC Controls BAC-8007 Installation Guide User Manual
Page 26
Getting started with
configuration
For access to the configuration functions you will need Password 2.
If the controller has not been previously set up, no password is required.
A new Password 2 can be entered or changed in the advance functions.
See the topic
.
Procedure
Detailed steps
STE display
1
Starting display
1.
Start at the temperature display.
2.
Press the
and
buttons together.
l
If Password 2 is not required, the display
changes to
CNFG
.
l
If required, enter Password 2. The display
changes to
CNFG
when Password 2 is
correct.
3
2
Enter Password 2.
1.
Press the
and
buttons together and hold
them down until the display changes to
PSW2
.
2.
Press the
or
button to change the first
digit.
3.
Press the
Set
Point
button to select the next digit.
Repeat for all four digits.
4.
When the button is pushed for the fourth
correct digit, the display changes to
COMM
.
Note:
If Password 2 has not previously been
entered the display will change to the
CNFG
display after Step 1.
237
////
3
Select a configuration
function.
Access to the configuration functions always start
at the
CNFG
display.
CNFG
Enter the configuration mode
Section 4: Configuring the controllers
SimplyVAV
26
Revision E