To set the fraction mark, Using system flags, Setting the fraction mark -6 – HP 48g Graphing Calculator User Manual
Page 55: Using system flags -7, Settings using the, Browser
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To set the fraction mark:
1. Press iTRfMODES).
2. Highlight the FM|: field, and press v ' C H K (or [+/-)) until the
desired setting is shown (checked—fraction mark is comma;
unchecked—fraction mark is period).
3. Press OK to confirm your choice, or CflNCL to cancel it.
Using System Flags
Most modes are controlled by system flags. The HP 48 has 64 system
flags, numbered —1 through —64. Each flag can have two states: set
(value of 1) or clear (value of 0). The system flags and the modes they
control are described in appendix D.
You can control modes by directly manipulating the system flags. You
can access the flags by using the Flag Browser, part of the MODES
application, or by using the F L
h
G command submenu.
Using the Flag Browser
The HP 48 uses two kinds of system flags: flags that single-handedly
determine a mode, and flags that work with others to determine a
mode. The Flag Browser lets you view and set the “single-handed”
flags.
To view or change
flag
settings using the
Flag
Browser:
1.
Press
f^fMODES).
2. Press F L
h
G to begin the Flag Browser.
'>1 General
iSYSTEM FLAGS_________
42
Constant ^ symb
43
Function symb
Payment at end
13 -S-V2 ■4' vector 4-
The Flag Browser
Modes 4-7