HP 48g Graphing Calculator - Manual (Page 371)

Setting Up the Printer
To set up the HP 82240B infrared printer:
1. Place the HP 48 and the printer on a flat surface. Aim the A
(near the Hewlett-Packard logo just above the display) toward
the window on the printer. Keep them within 18 inches (45
centimeters).
2. Press 34 (^7^ f^fMODES) Fd...FiG CF- to make sure flag-34
is clear (its default state).
3. If you previously pressed
O L D F 'R
for any reason, reset the variable
PRTPAR—ymss i^ fW I P R I N T F ^ -R T F ’F l F ? E S E T .
To set up a serial printer:
1. Connect the 9-pin end of an HP 48 serial cable to the serial printer.
If necessary, use a 9-pin to 25-pin adapter.
2. Keep the HP logo on the 4-pin connector facing up, then plug the
cable into the HP 48. You should feel it lightly snap into place.
3. If your printer uses XON/XOFF handshaking; Press
[ N X T 1
S E R IF i O P E N I [ N X T ) C -L u S E
to create lOPAR. Then press
(VAR 1 frR 10
P A R
p^fEDIT 1 and change the fourth number to 1—
for example,
C 9 6 8 0 8 8
1 3 1
> .
Press
[ E N T E R ) l U P f l R .
4. If your printer requires an end-of-line sequence other than
carriage-return/line-feed, press
f^ [l/0 ) F 'R l
to create
PRTPAR, then edit the end-of-line parameter (the fourth element
in the PRTPAR list).
27
Printing Tasks
To print an object wia infrared:
1. Be sure that the printer is setup properly and turned on.
2 .
Press
(SQZ3 ffl (I) (B
O ' "
to open the
P R I H l
form.
3. If necessary, press (B&D to change the communications port to
In f r .a re d .
Transmitting and Printing Data 27-3