Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, Firmware rev. 3.0 or LATER - Manual (Page 354)

354 Publication 1404-UM001F-EN-P - November 2009
Index
scrolling 43
serial communication 91
auto sense protocol 95
DF1 protocol 91
Modbus RTU slave protocol 92
setpoint control 139
setpoint inputs 141
setpoint programming and operation 123
equal 127
not equal 128
over forward 124
over reverse 125
under forward 126
under reverse 127
setting default screen 44
simple reads of data tables 87
specifications 335 , 337
control relay 338
general input, output and environmental
ratings 338
input and output ratings 338
measurement accuracy, resolution, and
range 337
relay life 338
status indicators 22
status input operations 141
counters 141
demand period synchronization 141
event logging of status inputs 142
setpoint inputs 141
symmetrical component analysis 31
system clock sample applications 282
date and time summary 304
EtherNet/IP and ControlLogix 287
MicroLogix controller and EtherNet/IP
communication networks 296
MicroLogix controller and Modbus
communication network 301
PLC-5 controller using Remote I/O 285
RSLinx DDE/OPC and MicroSoft Excel
291
SLC 500 controller and RS-485
communication 282
use OPC for single element password
write 295
T
theory of setpoint operation 123
tif 168
time of use 156
configuring the log 157
hours selection 156
reading the log 158
transient analysis configuration 180
transient detection metering and capture
179
clear command 185
configuration 180
reading capture data 182
reading metering data 181
U
under reverse setpoint 127
underforward setpoint 126
user-configured data table setup using
ControlLogix and EtherNet/IP
314
sample program operation 314
V
viewing metered data 29
voltage current and frequency results 30
W
writing data 83
writing setpoint configuration using
comms 134