Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, Firmware rev. 3.0 or LATER - Manual (Page 3)

3 Publication XXXX-X.X.X - Month Year 3
Summary of Changes
Introduction This release of this document contains new and updated information.
To find new and updated information, look for change bars, as shown
next to this paragraph.
Updated Information The document contains these changes
Topic Page
Added information about single-instance
parameters 19
Single instance parameter for DeviceNet 77
Added Single Element Writes to the primary
methods to communicate with a power
monitor 80
Added information for writing single
element data to a data table 86
Added information about floating-point
word order 100
Added information for configuring protocol
selections 103
Changed the placeholder from instance 99
to instance 255 110
Added information about changing the
configuration of Instance 1 in the user
configured table 122
Added information about setpoint output
action logic 128
Added an example of sag alarm for setpoint
operation 133
Changed element 3 range in the Discrete
Data table to 0…7 193
Updated the Native Communication
Configuration table, it has nine elements
and the range for element 3 is 0…6 198
Updated the optional communication
configuration table for Ethernet, adding
protocol selection as element 13 199
Updated the optional communication
configuration table for DeviceNet, adding
floating point data format as element 4 202
Changed the element 4 range in the RS-232
table to 0…6 203