Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, Firmware rev. 3.0 or LATER - Manual (Page 331)

Publication 1404-UM001F-EN-P - November 2009 331
Sample Applications Appendix C
PanelView Component HMI
and EtherNet/IP
Communication Network This example demonstrates reading and writing power monitor date,
time, and other configuration parameters by using a PanelView
Component HMI terminal, the single element password write, and the
EtherNet/IP communication network.
Please refer to applicable product literature for information on
configuration and use of the PanelView Component HMI terminal.
Illustrations in this example were made using a Firefox 2.x browser.
The power monitor master module firmware must be version 4.x or
later and PanelView Component HMI firmware must be version 1.11
or later. Power monitor Ethernet protocol selection may be either CIP
or CIP/CSP.
CHMI Communications Setup
In this example, controller 3k1 is a Powermonitor 3000 unit with IP
address 10.90.172.91. It is configured with controller type
Allen-Bradley MicroLogix/ENI:PLC-5.
When the swap operation is complete copy the temp file to the designated WR_TRANSFR file.
0002
EQU
Equal
Source A
N12:0
30<
Source B
62
62<
EQU COP
Copy File
Source
#N11:0
Dest #N14:0
Length 64
COP
0003
RET
Return
RET
0004 END