Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, Firmware rev. 3.0 or LATER - Manual (Page 217)

Publication 1404-UM001F-EN-P - November 2009 217
Powermonitor 3000 Data Tables Appendix A
22 Crest factor voltage
• • •
Refer to Harmonic Results; THD, Crest Factor, and More Parameters
23 Crest factor current
• • •
24 Crest factor I4
• • •
25
IEEE THD voltage
(1)
• • •
26
IEEE THD current
(1)
• • •
27 IEEE THD I4
• • •
28
IEC THD voltage
(1)
• • •
29
IEC THD current
(1)
• • •
30 IEC THD I4
• • •
31 Status input 1
• • •
Refer to Discrete Data Parameters
32 Status input 2
• • •
33
Any status input
(1)
• • •
34 Setpoint #1 time accumulator
• • •
Refer to Setpoint Output Actions Parameters
35 Setpoint #2 time accumulator
• • •
36 Setpoint #3 time accumulator
• • •
37 Setpoint #4 time accumulator
• • •
38 Setpoint #5 time accumulator
• • •
39 Setpoint #6 time accumulator
• • •
40 Setpoint #7 time accumulator
• • •
41 Setpoint #8 time accumulator
• • •
42 Setpoint #9 time accumulator
• • •
43 Setpoint #10 time accumulator
• • •
44
Voltage Sag
(2)
• •
Refer to Sag and Swell on page 174
45
Voltage Swell
(2)
• •
46
Transient detected
(2)
•
Triggers a setpoint when a transient has been detected
47 Avg IEEE THD V
• • •
Refer to Harmonic Results; THD, Crest Factor, and More Parameters
48 Avg IEEE THD I
• • •
49 Avg IEC thd V
• • •
50 Avg IEC thd I
• • •
51 Avg Crest Factor V
• • •
52 Avg Crest Factor I
• • •
(1) A setpoint activates when the magnitude of any phase passes the activation limit and releases when all phases pass the release limit in the appropriate direction for the
setpoint evaluation condition.
(2) These setpoint types apply only to the applicable Powermonitor 3000 models and will appear as inactive on other models.
List of Setpoint Types
Param.
No. Parameter Name M4
M5 M
6 M
8 Comment