JUMO 705010 mTRON T - Multichannel Controller Module Operating Manual - Manual (Page 92)

6 Configuration
92
Setup dialog
Parameters
Tolerance band
Parameter Selection/settings Description
Ramp function Off Ramp function is switched off.
On Ramp function is switched on.
Tolerance band Monitoring of deviation of the actual value from the current setpoint value (toler-
ance band = admissible deviation)
Inactive No monitoring
Symmetric Monitoring of the upper and lower toler-
ance band limits
Above setpoint value Monitoring of the upper tolerance band
limit
Below setpoint value Monitoring of the lower tolerance band
limit
Actual value Analog selector (Inactive) Monitored actual value of the relevant
controller
?
w, x
t
(3)
(4)
(2)
Dx = 0 ... 999.9
(1) w
(1) Tolerance band (3) Above setpoint value (upper limit)
(2) Symmetric (upper and lower limits) (4) Below setpoint value (lower limit)