JUMO 705010 mTRON T - Multichannel Controller Module Operating Manual - Manual (Page 129)

129
9 Online parameters
9.1 Calibrate / test
9.1.1 Analog input
Setup dialog
Parameters
TIP!
An active connection between the setup program and the central processing unit is required
to configure the parameters described in this section.
CAUTION!
Incorrect settings may result in inadmissible changes to values or statuses.
This can have negative effects on the system function.
Individual functions must be changed only by (or under the instruction of) a service technician
of the device manufacturer.
Parameter Selection/settings Description
Measuring input Select input (drop-down list). Input on which the calibration or test is
to be performed.
Sensor Select sensor (drop-down list). Sensor type that is connected at the rel-
evant input.
Actual value None Display of the actual value read out
Test Click the "Test" button. An additional window opens with
instructions for testing (see below).
?