JUMO 705010 mTRON T - Multichannel Controller Module Operating Manual - Manual (Page 55)

55
6 Configuration
6.5 Analog inputs
The analog inputs (maximum of four) are universal measuring inputs for RTD temperature
probes, thermocouples, resistance transmitters, resistance/potentiometers, and standard sig-
nals.
Setup dialog
Parameters
Parameter Selection/settings Description
Sensor Selection of measuring probe for the relevant analog input
Inactive No sensor selected
RTD temp. probe 2-w RTD temperature probe in 2-wire circuit
RTD temp. probe 3-w RTD temperature probe in 3-wire circuit
RTD temp. probe 4-w RTD temperature probe in 4-wire circuit
Resistance transmitter Resistance transmitter
Thermocouple
Heater current Heater current AC 0 to 50 mA
Current 0 to 20 mA Standard signal
Current 4 to 20 mA Standard signal
Voltage 0 to 1 V Standard signal
Voltage 0 to 10 V Standard signal
Voltage 2 to 10 V Standard signal