JUMO 705010 mTRON T - Multichannel Controller Module Operating Manual - Manual (Page 21)

21
3 Installation
Installation, using the example of a multichannel controller module 705010
Example installation
Procedure:
(A) (A1)
(A2)
Step Activity
1 Mount the multichannel controller module (A) in the DIN rail from above (A1).
2 Pivot the multichannel controller module (A) downward until it snaps into place (A2).
3 Move the multichannel controller module (A) to the left against the previous module (A3)
until the plug connections for the voltage supply and the system bus are connected.
4 Position additional modules (B) and move to the left against the previous module (B4).
5 After the final module, position the cover (C) on the DIN rail and move to the left against the
module (C5).
6 After attaching the cover, position the end bracket (D) on the DIN rail and move to the left
against the cover (D6).
7 Fasten the end bracket (D) using a screwdriver (D7). For this purpose, ensure that the end
bracket and the cover are positioned flush against the final module.
(D)
(C5) (D6)
(D7)
(C) (A)
(B4) (A3)
(B)