JUMO 705010 mTRON T - Multichannel Controller Module Operating Manual - Manual (Page 43)

43
5 Operation
5.3.1 Multichannel controller module
Operation of the multichannel controller module includes the following settings and functions:
•
Setpoint value entry
• Display of actual value, setpoint value, output level, switch setting of outputs, self-optimiza-
tion, manual mode, and ramp function
• Start of self-optimization
• Changeover to manual mode
• In manual mode: Specification of output level or actuator opening and closing
• Display of inputs and outputs (hardware) of the multichannel controller module
Controller screen – overview of controller channels 1 to 4 (controller 1 to 4)
This screen provides an overview of all controller channels that are switched on:
•
Actual value
• Setpoint value (display or input field; depends on the configuration and user rights)
• Output level
• Switch setting for outputs of the controller channel (K1, K2)
• Self-optimization, manual mode, ramp function (active/not active)
Controller channel 4 is switched on in this example; the actual value and setpoint value have
not yet been configured.
To select a particular controller channel, select the relevant tab at the top of the window. If a
controller channel is switched off, a gray area appears in the overview and the tab is not avail-
able. If only one controller channel is switched on, the controller screen for that particular con-
troller channel is displayed instead of this overview.
Select the tab on the right to open an overview screen with the inputs and outputs of the mul-
tichannel controller module.