JUMO 705010 mTRON T - Multichannel Controller Module Operating Manual - Manual (Page 140)

10 Retrofitting inputs/outputs
140
2 Attach terminal strip (B) to the contacts of the retrofitted module and attach the label with
the terminal numbers to the terminal strip. When doing so, ensure that the numbering on
the terminal strip matches the numbering on the front panel of the module insert.
3 Reattach all wired terminal strips (A). Restart the system.
4 Configure the retrofitted inputs or outputs with the setup program or multifunction panel. Do
not perform wiring until this is complete.
5 Test the correct function of the whole plant under supervision.
Step Activity
TIP!
When inserting the module insert, ensure that the snap holders (under the grooved surfaces)
audibly snap into place.
CAUTION!
If a retrofitted module is removed again, an opening is left in the front panel of the module
insert.
Protection type IP20 is no longer guaranteed in this case.
To avoid this situation, the cover plate that was removed during the retrofit must be refitted
at the opening. The cover plate should be retained for this reason.