JUMO 705010 mTRON T - Multichannel Controller Module Operating Manual - Manual (Page 115)

115
6 Configuration
6.14.5 Replacement values (overview)
The following table contains the replacement values with their factory settings. Replacement
values can only be configured in the setup program.
Digital signals
Analog signals
Category Signal Factory
setting Description
Controller NV_C01TuneStop to
NV_C04TuneStop On Abort self-optimization
NV_C01ParamSet to
NV_C04ParamSet Off Changeover from parameter
block 1 to parameter block 2
NV_C01ManualMode to
NV_C04ManualMode Off Changeover to manual mode
NV_C01Stop to NV_C04Stop Off Controller channel active/inactive
Setpoint values NV_SP01Changeover1 to
NV_SP04Changeover1 Off Bit 0 of setpoint changeover
NV_SP01Changeover2 to
NV_SP04Changeover2 Off Bit 1 of setpoint changeover
NV digital inputs NV_DO03 to NV_DO10 Off Signal for controlling the digital
output
Acknowledge-
ment of limit
value monitoring NV_LI01Confirmation to
NV_LI04Confirmation Off Signal for acknowledging the out-
put signal of limit value monitoring
Signal suppres-
sion NV_SR01 to NV_SR08 Off Signal for activating signal sup-
pression
Signal Selection Factory
setting
1
1
No value is specified by default (display: ---).
Description
Controller NV_C01ActualValue to
NV_C04ActualValue --- Actual value for controller channel
NV_C01Setpoint to
NV_C04Setpoint --- Setpoint value for controller chan-
nel
Setpoint values NV_SP01Ext to NV_SP04Ext --- External setpoint value (freely
available)
Math NV_M01Flag to NV_M04Flag --- Any analog value
(freely available)