JUMO 705010 mTRON T - Multichannel Controller Module Operating Manual - Manual (Page 137)

137
10 Retrofitting inputs/outputs
This section describes how to retrofit the modules for the optional inputs and outputs (expan-
sion slot 1 to 3) on multichannel controller module 705010.
Identifying the module
The module can be identified using the part no. on the packaging.
CAUTION!
Incorrect handling may result in damage or malfunctions.
This compromises the function of the multichannel controller module or of the system as a
whole.
Only qualified personnel are permitted to carry out module retrofits. Existing country-specific
requirements for changes at an electrical device have to be observed. Before a retrofit, the
system must be shut down and isolated from the power supply. Prior to using the retrofitted
inputs or outputs, ensure that these have been configured correctly.
CAUTION!
Modules may be damaged by electrostatic discharge.
This compromises the function of the multichannel controller module or of the system as a
whole.
Modules may only be retrofitted at a grounded workstation and in compliance with the rele-
vant safety measures.
Module Code
(order
code) Part no. For use in expan-
sion slot
Analog input (universal) 1 00569497 1 (F), 2 (G)
Relay (changeover contact) 2 00569498 1 (F), 2 (G), 3 (H)
2 relays (N/O contacts with common pole) 3 00569499 1 (F), 2 (G), 3 (H)
Analog output (configurable) 4 00569500 1 (F), 2 (G), 3 (H)