JUMO 705010 mTRON T - Multichannel Controller Module Operating Manual - Manual (Page 30)

4 Electrical connection
30
4.3 Connection diagram
CAUTION!
At maximum load, the temperature may exceed 60 °C at the terminals.
As a result the insulation of the cable may be damaged.
The cable must be heat resistant up to at least 80 °C.
CAUTION!
The controller module configuration does not necessarily correspond to the intended appli-
cation during initial startup (e.g. "Independent controller" operating mode active).
This may result in undefined plant behavior.
Therefore, where possible during startup, no actuators should be connected and load current
circuits should be isolated. The plant installer is essentially responsible for the startup pro-
cess.