JUMO 705010 mTRON T - Multichannel Controller Module Operating Manual - Manual (Page 44)

5 Operation
44
Controller screen – controller channel 1: Two-state controller in automatic mode
Controller screen – controller channel 2: Two-state controller in manual mode
(8) (1)
(7)
(6)
(5)
(2)
(3)
(4)
(1) Switch setting of output 1 (K1)
and 2 (K2) of the controller channel
(2) Display of self-optimization, manual mode,
ramp function (from left to right)
(3) Changeover to manual mode (4) Self-optimization start/stop
(5) Display of output level (bar graph) (6) Display of output level (percent)
(7) Input field for setpoint value or setpoint
value display (depends on configuration)
(8) Display of actual value
(3)
(1)
(2)
(1) Manual mode is active (2) Changeover to automatic mode
(3) Input field for output level