JUMO 705010 mTRON T - Multichannel Controller Module Operating Manual - Manual (Page 107)

107
6 Configuration
6.14.2 Digital signals
Setup dialog
Parameters
Replacement value
The replacement value is used if the relevant signal is not available (connection to base unit
interrupted or system in "Stop" state).
Parameter Selection/settings Description
Digital signal /
Value Select input to be connected. List of external inputs of the module
If a connection has already been config-
ured, the module and its signal are dis-
played in the "Value" column.
...\NV_C01Tune-
Start
(Example)
This is the previously selected external input.
Select the module and – in the selector
next to it on the right – the signal to con-
nect to the external input. List of modules in the system and the
relevant signals
Replacem. value Replacement value for the relevant signal
OFF Low level (0)
ON High level (1)
?
?