JUMO 705010 mTRON T - Multichannel Controller Module Operating Manual - Manual (Page 75)

75
6 Configuration
6.9.3 Self-optimization
Self-optimization (SO) determines the optimum controller parameters for a PI or PID controller.
Setup dialog
Parameters
Parameter Selection/settings Description
Method Oscillation Oscillation method
Step response Step response method
SO output 1, 2 Type of the first or second controller output
Switched Relay output
Semiconductor Solid state relay output, open-collector
output, or logic output
Continuous Analog output
Standby outp.
level -100 to 0 to +100 Output level at start of self-optimization
(for step response method)
Step size 10 to 30 to 100 Size of output level step (for step
response method)
Acceptance CY Transfer of Cy cycle time after completion of self-optimization
No No transfer
Yes Transfer
Allow tune Allow self-optimization generally
No Self-optimization not permitted
Yes Self-optimization permitted
?
?