JUMO 705010 mTRON T - Multichannel Controller Module Operating Manual - Manual (Page 45)

45
5 Operation
Controller screen – controller channel 3: Modulating controller in manual mode
(1)
(2)
(1) Open actuator (2) Close actuator
TIP!
If the modulating controller is in manual mode, the actuator can also be opened and closed
in the "Stop" system state.
TIP!
If the output level feedback of the position controller is "out of range", the current position of
the actuator can no longer be determined. In this case, the actuator can be operated with but-
tons (1) and (2), as for the three-step controller. The commands "Open actuator" or "Close
actuator" are issued for as long as the relevant button is held.