JUMO 705010 mTRON T - Multichannel Controller Module Operating Manual - Manual (Page 106)

6 Configuration
106
6.14.1 Analog signals
Setup dialog
Parameters
Replacement value
The replacement value is used if the relevant signal is not available (connection to base unit
interrupted or system in "Stop" state).
If necessary, an invalid value can also be used (entry: -----).
Parameter Selection/settings Description
Analog signal /
Value Select input to be connected. List of external inputs of the module
If a connection has already been config-
ured, the module and its signal are dis-
played in the "Value" column.
...\NV_C01Actual
Value
(Example)
This is the previously selected external input.
Select the module and – in the selector
next to it on the right – the signal to con-
nect to the external input. List of modules in the system and the
relevant signals
Replacem. value Replacement value for the relevant signal
-99999 to +99999
(or invalid value: -----)
An invalid value is specified by default
(display: -----).
?