JUMO 705010 mTRON T - Multichannel Controller Module Operating Manual - Manual (Page 80)

6 Configuration
80
6.9.4 K-Controller
The following functions are used in the plastics industry and require special skills. Configuration
should only be performed by specialists.
Boost function
The boost function is used to remove plastic residue in the tools during the production process.
The setpoint values of all heating zones are increased by a specific value for a specific amount
of time.
A setpoint value offset is also taken into account when the boost function is active.
The boost function is also active when setpoint value 2, 3, or 4 is active. If setpoint value
changeover occurs during the active boost phase, the boost function is aborted.
Setup dialog
Parameters
Parameter Selection/settings Description
Function Without function Boost function is switched off.
Absolute value Setpoint value is increased by an abso-
lute value.
Percentage value Setpoint value is increased by a per-
centage value.
Start signal Digital selector (Inactive) Signal for starting the boost function
(active in the case of a falling edge)
Value -99999 to 0 to +99999 Amount by which the setpoint value is
increased (in K or % of setpoint value).
Boost period 00:00:00 to 99:59:59 Length of boost period (hh:mm:ss)
?