JUMO 705010 mTRON T - Multichannel Controller Module Operating Manual - Manual (Page 54)

6 Configuration
54
6.4 Device data
The settings apply for the entire controller module.
Setup dialog
Parameters
Independent controller
The controller module can operate independently, meaning that if communication fails between
the controller module and the central processing unit, the control task continues to be per-
formed.
 Chapter 6.3 ""Independent controller" operating mode", page 52
Status after change of configuration
The settings are available immediately after configuration.
Behavior after power on
The settings are available immediately after initialization.
Parameter Selection/settings Description
Sampling rate Sampling rate of the internal inputs and external inputs (system bus)
T50ms The signal is sampled every 50 ms.
T100ms The signal is sampled every 100 ms.
T150ms The signal is sampled every 150 ms.
T200ms The signal is sampled every 200 ms.
T250ms The signal is sampled every 250 ms.
Contr. indepen-
dent Enable "Independent controller" operating mode.
Yes "Independent controller" operating mode
is enabled.
No "Independent controller" operating mode
is not enabled.
?