Setting up a control surface, Using the onscreen controls, P. 60) – Apple Color 1.0 User Manual
Page 60: 60 chapter 3 using the color interface
60
Chapter 3
Using the Color Interface
Setting Up a Control Surface
Color was designed from the ground up to support control surfaces specifically
designed for color correction from manufacturers such as Tangent and JL Cooper
Designs. These control surfaces typically include three trackballs that correspond to the
three overlapping tonal zones of the Primary and Secondary color balance controls
(shadows, midtones, and highlights), three rotary controls for the three contrast
controls (black level, gamma, and white point), and a number of other rotary controls
and buttons that support different functions depending on which room you’ve
selected.
You can either choose a control surface to use when Color starts up, or you can click
Show Control Surface Dialog in the User Prefs tab of the Setup room to choose an
available control surface at any time. For more information on setting up a control
surface, see Appendix C, “
.” For more information on
configuring a control surface from within Color, see “
Using the Onscreen Controls
If you don’t have a control surface, you can still operate every feature in Color using the
onscreen controls. In addition to the standard buttons, check boxes, and pop-up
menus common to most applications, Color uses some custom controls that are
described in this section.
F1
F2
F3
F4
F5
F6
F7
F8
F9
MEM
ALT
GRACE
DELETE
OUT
IN
MARK
CUE
DO
UNDO
MORE
REDO
7
4
1
00
0
2
3
-
5
6
+
8
9
PREV
NEXT
MODE
CLEAR
B3
R3
B2
B1
R1
R2
PAGE 5
PAGE 6
PAGE 8
PAGE 7
PAGE 1
PAGE 2
PAGE 4
PAGE 3
F1
M1
W1
W2
W3
W4
W5
W6
W7
JOG
SHUTTLE
M2
M3
1
2
3
4
5
6
7
8
BANK 1
BANK 2
HOURS
MINUTES
SECONDS
FRAMES
BANK 4
BANK 4
PAGE
ASSIGN
UTILITY
M4
M5
TIME CODE DISPLAY
F2
F3
F4
F5
F6
F7
F8