Outback Power Systems MATE3 Owners Manual - Manual (Page 83)

System Settings
900-0117-01-00 Rev C 81
Change Installer Password
The Change Installer Password screen allows changes to the installer password so that access to the full
menus can be restricted to those who know the new password (OEMs or installers).
IMPORTANT:
Changes to system settings should only be made by qualified personnel or
under the direction of OutBack Technical Support.
Figure 88 Change Installer Password
Challenge Installer Password
If the installer password is lost or forgotten, this process is used to reset access to the device. The screen
will generate a challenge code as shown below. Once the installer has the challenge code, it is necessary
to contact OutBack Technical Support (see inside front cover) to obtain a temporary “challenge password”
that corresponds with the MATE3-generated challenge code. After entering a valid challenge password,
the MATE3 will immediately display the
Change Installer Password screen. The installer should change
the password according to their preferences.
Figure 89 Challenge Installer Password
Set Points:
 Set points include four numerical digits from 0 to 9.
 The default installer password is 1732.
Set Points:
 Set points include four numerical digits from 0 to 9.