Outback Power Systems MATE3 Owners Manual - Manual (Page 80)

Programming
78 900-0117-01-00 Rev C
Sound
The Sound menu item allows the user to enable, or disable, sounds when a button is pushed or the control
wheel is used.
Figure 80 Sound
Ethernet Addresses
IMPORTANT:
 Using this feature requires advanced knowledge of network administration and
internet protocols. Due to the various types of routers available, specific instructions
for setting up this feature will vary also.
 The IP address must be unique. It cannot be the same as any other device on
the network.
 For additional information, see the Support section of the OutBack web site.
To connect the MATE3 to a personal computer or network, it may be necessary to manually set the
IP address, netmask, gateway, DNS-1, and DNS-2 (optional) addresses to the host router.
Figure 81 Ethernet Addresses
Set Points:
 Button Beep – Enabled or Disabled
 Wheel Click – Enabled or Disabled
Set Points:
 DHCP (Dynamic Host Configuration Protocol) –
Enabled. This allows the MATE3 to be assigned
the IP address, netmask, gateway, DNS-1 and
DNS-2 numbers from a router.
Set Points:
 DHCP (Dynamic Host Configuration Protocol)
– Disabled. This allows the user to set the
following parameters.
 IP Address – 192.168.xxx.xxx*
(Default IP address is 192.168.0.64)
 Netmask – 255.255.255.000 *
 Gateway – 192.168.xxx.xx1*
 DNS-1 –192.168.xxx.xx2 *
 DNS-2 –192.168.xxx.xx3 *
(*this can vary by installation.)
Use for the following application:
 Connecting to a router on an Intranet.
See page 24.
Use for the following applications:
 Connecting directly to a computer.
See page 22.
 Connecting to a computer through a
network switch. See page 23.
 Connecting to a computer to the MATE3
through the Internet. See page 26.