Outback Power Systems MATE3 Owners Manual - Manual (Page 77)

System Settings
900-0117-01-00 Rev C 75
Saving a Configuration to an SD Card
Figure 75 Saving the Configuration to an SD Card
To save a configuration to an SD card:
1. From the Main Menu, select Settings.
2. From the Settings Menu, select System.
3. From the System Configuration menu, select
Save/Restore Information.
4. Select the Save System Configuration menu item.
5. If other profiles have been saved on the SD card, a list will
be displayed. Choose one of the following options.
 Press to save the new settings over the name
that is selected on the list.
OR
 Press to create a new name for the profile.
See the instructions below for entering a new name.
OR
6. After performing one of the two options above,
press
to return to the Main Menu.
To save the new profile over the name highlighted on the list:
1. Use the control wheel to scroll through the list.
2. When the name to be replaced is highlighted, press .
3. Wait for the message confirming that the profile has been saved
to the SD card.
4. Press to return to the Main Menu.
To create a new name for the profile (up to 8 characters
maximum):
1. Use the control wheel to scroll through the available characters.
2. Use <> or <> to move to the desired character location.
3. Press to erase the character that is highlighted.
4. Press to save the new profile on the SD card.
5. Press to return to the Main Menu.
NOTE: If the SD card is empty, pressing the soft
key will automatically default to the New Wizard
Configuration File menu to allow a name to be
entered (up to 8 characters maximum).
Returns to the Main Menu.
Returns to the Main Menu.