Outback Power Systems MATE3 Owners Manual - Manual (Page 140)

Programming
138 900-0117-01-00 Rev C
Saving the Profile to an SD Card
Once the settings are applied to the system, they can be saved to an SD card for future use.
Figure 167 Saving the Configuration to an SD Card
To save a configuration to an SD card:
1. From the System Programmed screen (see Figure 163),
press . The Save Configuration Wizard screen
will appear.
2. If other profiles have been saved on the SD card, a list will
be displayed. Choose one of the following options.
 Press to save the new settings over the name
that is selected on the list.
OR
 Press to create a new name for the profile.
See the instructions below for entering a new name.
OR
 Press to exit without saving and returns the
user to the Main Menu.
3. After saving the profile to the SD card is complete, press
to return to the Main Menu.
To save the new profile over the name highlighted on the list:
1. Use the control wheel to scroll through the list.
2. When the name to be replaced is highlighted, press .
3. Wait for the message confirming that the profile has been saved
to the SD card.
4. Press to return to the Main Menu.
To create a new name for the profile (up to 8 characters
maximum):
1. Use the control wheel to scroll through the available characters.
2. Use <> or <> to move to the desired character location.
3. Press to erase the character that is highlighted.
4. Press to save the new profile on the SD card.
5. Press to return to the Main Menu.
NOTE: If the SD card is empty, pressing
will automatically default
to the
New Wizard Configuration
File menu to allow a name to be
entered (up to 8 characters
maximum).
Returns to the Main Menu.
Returns to the Main Menu.
See the sample data log on page 141.