Outback Power Systems MATE3 Owners Manual - Manual (Page 139)

Configuration Wizard
900-0117-01-00 Rev C 137
Applying the Profile to the System
Once the configuration parameters are complete, the settings must be applied to the system.
Figure 166 Applying the Profile to the System
IMPORTANT:
Failure to apply the profile to the system as described above can result in the
settings not being saved to the MATE3's internal flash memory. This can result
in the system not being programmed properly.
To apply the profile to the system:
1. From the Setup Complete screen, press .
NOTE:
 Pressing at this point WILL NOT save the
changes to the MATE3 internal memory and all
changes will be lost.
 Pressing at this point will proceed to the Save
Configuration Wizard screen (Figure 167) WITHOUT
applying the profile to the system and the changes will
be lost.
2. Wait while the settings are applied to the system. The
screen will display
Programming System. When this step
is complete, the screen will display System Programmed.
3. When the screen displays System Programmed, choose
one of the following options.
 Press to return to the Main Menu, or
 Press to save the configuration on an SD card
for future use. See Figure 167.