Outback Power Systems MATE3 Owners Manual - Manual (Page 132)

Programming
130 900-0117-01-00 Rev C
Configuration Wizard
The Configuration Wizard is a guided program that assists in configuring system setups. An installer can
create new configurations, use existing configurations, or restore configurations to their original state.
Creating New Configurations
Figure 162 Creating New Configurations using the Configuration Wizard
Soft Keys:
moves back one screen.
moves forward to the next screen. Set Points:
System Type (see page 74):
 System Type
 System Voltage
 Array Wattage
 Battery Type/Capacity
Battery Charging (see pages 89 and 89):
 Absorb Voltage/Time
 Float Voltage/Time
 Equalize Voltage/Time
 Re-Float Voltage
AC Configuration (See pages 83 - 87, and 100):
 AC Output Voltage (Vac)
 AC Phase
 AC Input Breaker Size (amps)
 Maximum Output Load (amps)
Generator Configuration (See pages 74 and 115):
 Generator Installed – Y or N
 Generator Type – AC or DC
 Size – 0.0 to 150.0
 Generator Start (manual, auto)
 Aux Output Device Port – 1
 Control (Radian only; AUX Relay or AUX Output)
Continued on next page...
To create a new configuration:
1. Access the Main Menu as shown in Figure 71.
2. Select the Configuration Wizard menu.
3. Select New Configuration.
4. Press to confirm the creation of a
new configuration.
5. Use the control wheel to adjust the settings in
each screen where required. Record the settings
on the form provided in Table 11.