Outback Power Systems MATE3 Owners Manual - Manual (Page 75)

System Settings
900-0117-01-00 Rev C 73
Settings Menus
 The system Settings menus are used for programming functions for the overall system
(e.g., date and time, communication options).
 The device Settings menus are used to program the various system components (e.g., inverter, charge
controller, battery monitor, and MATE3). The system profile is made up of the combination of all these settings.
 The Settings menus are accessed in the Main Menu using the Lock key.
See Figure 71 on page 71 for instructions on accessing the Main Menu .
 Once the settings have been changed to match the configuration, they are stored in the MATE3's static memory.
 It is recommended once the configuration has been established, save the data to an SD card. That way, the
configuration can be restored without having to repeat each setting individually.
IMPORTANT:
If multiple inverters are used in the installation, make certain to change
settings as appropriate for each inverter on its assigned port. Changing
settings for a single inverter in a multiple-inverter system may result in conflicts
in operation.
Settings Menu See pages... Notes
System below to
page 80
Inverter 82 to 103 See the inverter Operator’s Manual for details about functional
features of the inverter.
Charge Controller 104 to 111 Detailed information about basic setup for a FLEXmax charge
controller is available in the FLEXmax 60/80 Charge Controller
Owner’s Manual.
The MATE3 can be connected to an MX60 Charge Controller, but
only monitoring features will be available. The MATE3 will not
be able to program the MX60.
Battery Monitor 112 to 114 Detailed information about basic setup for a FLEXnet DC is
available in the FLEXnet DC Owner’s Manual.
MATE3 115 to 129
System Settings
System Settings menu include the following menu options:
 System Information --------------------------------------- > See page 74.
 Save/Restore Configuration --------------------------- > See page 74.
 Firmware Version ------------------------------------------ > See page 76.
 Date and Time ----------------------------------------------- > See page 74.
 LCD Display --------------------------------------------------- > See page 77.
 Sound ----------------------------------------------------------- > See page 78.
 Ethernet Addresses ---------------------------------------- > See page 78.
 Ethernet Ports ----------------------------------------------- > See page 79.
 Data Stream -------------------------------------------------- > See page 79.
 System Name ------------------------------------------------- > See page 79.
 Installer Information -------------------------------------- > See page 80.
 Installer Settings ------------------------------------------- > See page 80.