Event logs, Programming – Outback Power Systems MATE3 Owners Manual User Manual
Page 144
Programming
142
900-0117-01-00 Rev C
Event Logs
When events occur that affect the system or cause a shutdown, an event message occurs. Events are
recorded at intervals to the MATE3 flash memory at intervals programmed in the MATE3 settings.
(See Figure 153 on page 122.)
Event notifications are shown
445H452H
Figure 158 on page 150.
How to review event messages is shown in
447H454H
Figure 159 on page 151.
Event logs can be downloaded to an SD Card or deleted from the MATE3 internal memory.
To Save an Event Log
Figure 173 Saving Event Logs
To save an event log:
1. Access
the
Main Menu as shown in Figure 71.
2. Select
the
Event Logs menu.
4. Select
Save Events to SD Card.
5. On
the
Date Range set point, use the control wheel to select the
date for the event log (or logs) to be saved to the SD card. The
range will start with "
All" and will move backward to yesterday,
up to one year's worth of logs.
6.
If a log with a specific date is desired, then use the control wheel
to scroll through the list. When the name to be saved is selected,
press
7.
After performing the desired action, press
to the
Event Logs
menu.
To save an event log over the name highlighted on the list:
1.
With the correct name highlighted, press
2.
Wait for the message confirming that the event log has been
saved to the SD card.
3.
After the save action is complete, press
the
Event Logs menu.
Returns to the
Event Logs screen.
NOTE: If the SD card is empty, pressing
the
New Data Log File menu to allow
a name to be entered (up to
8 characters maximum).
Continued on the next page...