Outback Power Systems MATE3 Owners Manual - Manual (Page 71)

900-0117-01-00 Rev C 69
Programming
Programming an OutBack system may involve the following settings.
 System settings (page 72). These include:
~ System Information ------------------------------------------------ > See page 73.
~ Save/Restore Configuration ------------------------------------ > See page 74.
~ Firmware Revision -------------------------------------------------- > See page 76.
~ Date and Time -------------------------------------------------------- > See page 74.
~ LCD Display ------------------------------------------------------------ > See page 77.
~ Sound -------------------------------------------------------------------- > See page 78.
~ Ethernet Addresses ------------------------------------------------- > See page 78.
~ Ethernet Ports -------------------------------------------------------- > See page 79.
~ Data Stream ----------------------------------------------------------- > See page 79.
~ System Name ---------------------------------------------------------- > See page 79.
~ Installer Information ----------------------------------------------- > See page 80.
~ Installer Settings ---------------------------------------------------- > See page 79.
 Inverter parameters (page 82). These include:
~ Search -------------------------------------------------------------------- > See page 82.
~ AC Input Current Limit -------------------------------------------- > See page 83.
~ Grid AC Input Voltage Limits (FX-class only) ------------- > See page 85.
~ Gen AC Input Voltage Limits (FX-class only) -------------- > See page 85.
~ Grid AC Input Mode and Limits (Radian-class only) ---- > See page 86.
~ Gen AC Input Mode and Limits (Radian-class only) ---- > See page 87.
~ AC Output -------------------------------------------------------------- > See page 88.
~ Low Battery ------------------------------------------------------------ > See page 88.
~ Battery Charger ------------------------------------------------------ > See page 89.
~ Battery Equalize ----------------------------------------------------- > See page 89.
~ Auxiliary Output ----------------------------------------------------- > See page 90.
~ Auxiliary Relay (Radian-class only) -------------------------- > See page 96.
~ Inverter Stacking ---------------------------------------------------- > See page 99.
~ Grid-Tie Sell ------------------------------------------------------------ > See page 101.
~ Calibrate ---------------------------------------------------------------- > See page 102.
~ Reset Inverter to Factory Defaults ---------------------------- > See page 103.
 Charge Controller limits (page 104). These include:
~ Charger ------------------------------------------------------------------ > See page 104.
~ MPPT --------------------------------------------------------------------- > See page 105.
~ Temperature Compensation ------------------------------------ > See page 106.
~ Battery Equalize ----------------------------------------------------- > See page 106.
~ Grid Tie Mode -------------------------------------------------------- > See page 107.
~ Auxiliary Output ----------------------------------------------------- > See page 107.
~ Restart Mode ---------------------------------------------------------- > See page 110.
~ Calibrate ---------------------------------------------------------------- > See page 110.
~ Reset to Factory Defaults ----------------------------------------- > See page 111.
 Battery Monitor parameters (page 112). These include:
~ Battery Setup --------------------------------------------------------- > See page 112.
~ Shunt Enable ---------------------------------------------------------- > See page 112.
~ Relay Mode ------------------------------------------------------------- > See page
278H286H
113.
~ Relay Set Points ------------------------------------------------------ > See page
279H287H
113.
~ Reset FLEXnet DC to Factory Defaults ----------------------- > See page
280H288H
114.