Outback Power Systems MATE3 Owners Manual - Manual (Page 137)

Configuration Wizard
900-0117-01-00 Rev C 135
Restoring Configurations
Restoring configurations allows the installer to restore a system back to a profile that had been saved on
an SD card.
Figure 165 Restoring Configurations
Soft Keys:
moves back one screen.
moves forward to the next screen.
Set Points:
System Type (see page 74):
 System Type
 System Voltage
 Array Wattage
 Battery Type/Capacity
Battery Charging (see pages 89 and 89):
 Absorb Voltage/Time
 Float Voltage/Time
 Equalize Voltage/Time
 Re-Float Voltage
AC Configuration (See pages 83 - 87, and 100):
 AC Output Voltage (Vac)
 AC Phase
 AC Input Breaker Size (amps)
 Maximum Output Load (amps)
Generator Configuration (See pages 74 and 115):
 Generator Installed – Y or N
 Generator Type – AC or DC
 Size – 0.0 to 150.0
 Generator Start (manual, auto)
 Aux Output Device Port – 1
...continued on next page.
To restore a profile from an SD Card:
1. Access the Main Menu as shown in Figure 71.
2. Select the Configuration Wizard menu.
3. Select Restore Configuration. The MATE3 will access the SD
card and display the names of the profiles that are available
on the SD card to be restored.
4. Use the control wheel to scroll through the names.
5. When the desired profile is selected, press the
soft key to start the restoration process. This will give the
installer the opportunity to go through each configuration
screen to confirm it is accurate. Use the control wheel to
adjust the settings in each screen where required. Record the
settings on the form provided in Table 11.
4. Press to advance to the next screen.