Outback Power Systems MATE3 Owners Manual - Manual (Page 134)

Programming
132 900-0117-01-00 Rev C
Using Existing Configurations
The Use Existing Configurations menu allows the installer to apply a configuration that has previously
been saved on the MATE3 to the system being programmed.
Figure 163 Using Existing Configurations using the Configuration Wizard
To use an existing configuration:
1. Access the Main Menu as shown in Figure 71.
2. Select the Configuration Wizard menu.
3. Select Existing Configuration. This will take the
last configuration stored in the MATE3 and apply
it to the system.
4. When Using Existing Configuration is
displayed, press the soft key to start
the programming process.
5. Once the program is complete, press to
return to the
Main Menu or press to save
the configuration to an SD card.
See Figure 167 for instructions on saving the
configuration to an SD card.
returns to
the
Main Menu.
saves the new
profile to an SD card for
future use.