Outback Power Systems MATE3 Owners Manual - Manual (Page 116)

Programming
114 900-0117-01-00 Rev C
Reset FLEXnet DC to Factory Defaults
This menu allows the user to erase undesirable settings from the battery monitor and start over with the
values programmed at the factory. These values are listed in the FLEXnet DC Owner’s Manual.
Figure 141 Restoring the FLEXnet DC Monitor to Factory Default Settings
Press to return to
the
Battery Monitor menu.
To access the Reset to Factory Defaults menu:
1. Access the Main Menu as shown in Figure 71.
2. Select the Settings Menu. (This option may be
highlighted by default.)
3. Select Battery Monitor in the device Settings Menu.
4. Select the Reset to Factory Defaults menu.
5. Use the soft keys to select No or Yes.
 If is selected, the screen returns to the
Battery Monitor menu. No changes will be
made to any settings.
 If is selected, the battery monitor's settings
will immediately change to the original factory
values. The screen will display the message
FLEXnet DC Restored to Factory Defaults.
A soft key will appear. Pressing this
key will return the screen to the
Battery Monitor
menu.
6. After resetting the battery monitor to factory default
parameters:
 press the soft key or the Up
navigation key to return to the Battery Monitor
menu, or
 press the Top navigation key to return to the
Settings Menu.