Outback Power Systems MATE3 Owners Manual - Manual (Page 135)

Configuration Wizard
900-0117-01-00 Rev C 133
Figure 164 Modifying an Existing Configuration
Soft Keys:
moves back one screen.
moves forward to the next screen.
Set Points:
System Type (see page 74):
 System Type
 System Voltage
 Array Wattage
 Battery Type/Capacity
Battery Charging (see pages 89 and 89):
 Absorb Voltage/Time
 Float Voltage/Time
 Equalize Voltage/Time
 Re-Float Voltage
AC Configuration (See pages 83 - 87, and 100):
 AC Output Voltage (Vac)
 AC Phase
 AC Input Breaker Size (amps)
 Maximum Output Load (amps)
Generator Configuration (See pages 74 and 115):
 Generator Installed – Y or N
 Generator Type – AC or DC
 Size – 0.0 to 150.0
 Generator Start (manual, auto)
 Aux Output Device Port – 1
 Control (Radian only; AUX Relay or AUX Output)
Continued on next page...
To modify an existing configuration:
1. Access the Main Menu as shown in Figure 71.
2. Select the Configuration Wizard menu.
3. Select Existing Configuration.
4. Select . This will bring up the four
Configuration Wizard programming screens.
5. Use the control wheel to adjust the settings in each
screen where required. Record the settings on the
form provided in Table 11.