Outback Power Systems MATE3 Owners Manual - Manual (Page 76)

Programming
74 900-0117-01-00 Rev C
System Information
The System Information screen contains a basic profile of the system.
 Type of system (Off Grid, Grid Tied, Backup)
 Nominal voltage of the battery bank
 Array wattage (PV)*
 Battery Amp-hours
 Generator kW rating* and type
 Inverter and charger kW rating*
*Used to scale the Home screen meter bars.
Figure 73 System Information Menu Item
Save / Restore Configuration
The Save / Restore Configuration allows for saving a configuration to an SD card after manual
programming is complete. It is also used to restore (or copy) a configuration from an SD card to an
identical system configuration.
Figure 74 Save / Restore Configuration Menu Item
 Nominal Voltage – Allows for a battery bank with a
voltage of 12, 24, 36, 48 or 60 Vdc.
 Battery Ah – Allows for total amp-hour rating of
the batteries from 25 Ah to 10,000 Ah.
 Generator Type – Allows for an AC or DC
Generator, or None.
 Maximum Charger kW Rating – Allows for a
system with a total charger rating of 0 to 60 kW.
Set Points:
 Type – Off Grid, Grid Tied, Backup. See page 33
for details on the respective Home screens.
 Array Wattage – Allows for a PV Array (or arrays)
with a total wattage range of 0 to 50 kW.
 Generator kW Rating – Allows for a generator
with a range of 0 to 250 kW.
 Maximum Inverter kW Rating – Allows for an
inverter system with a wattage of 0 to 72 kW.