Outback Power Systems MATE3 Owners Manual - Manual (Page 133)

Configuration Wizard
900-0117-01-00 Rev C 131
Figure 162 Creating New Configurations using the Configuration Wizard (continued)
Set Points:
Wizard Grid Use Schedule (see page 126):
 Period 1 Enable - N or Y
 Weekday Use - 0:00 Drop 0:00
 Weekend Use - 0:00 Drop 0:00
 Period 2 Enable - N or Y
 Weekday Use - 0:00 Drop 0:00
 Weekend Use - 0:00 Drop 0:00
 Period 3 Enable - N or Y
 Weekday Use - 0:00 Drop 0:00
 Weekend Use - 0:00 Drop 0:00
Wizard High Battery Transfer (See pages 122 and 125):
 Mode – Y or N
 Grid Connect - xx.x VDC Delay xx min
 Grid Disconnect - xx.x VDC Delay xx min
 Grid Connect SOC xx% Disconnect SOC xx%
Wizard Battery Monitor (See page 112):
(These screens will only be available if a FLEXnet DC Battery
Monitor is installed in the system.)
Shunt A:
 Connection - Disabled, Inverter, Charge
Controller, DC Load, DC Gen, Wind Turbine, Hydro
Shunt B:
 Connection - Disabled, Inverter, Charge
Controller, DC Load, DC Gen, Wind Turbine, Hydro
Shunt C:
 Connection - Disabled, Inverter, Charge
Controller, DC Load, DC Gen, Wind Turbine, Hydro
...continued from previous page.
Soft Keys:
moves back one screen.
moves forward to the next screen.
Pressing from the last setup screen takes the user to the
Setup Complete screen. See Figure 166 to apply the changes to the system.