Outback Power Systems MATE3 Owners Manual - Manual (Page 141)

Data Logs
900-0117-01-00 Rev C 139
Device Data Logs
Users can create Device Data Logs for the FLEXmax (FM) Charge Controller and the FLEXnet (FN) DC
Battery Monitor. The Data Logs can then be uploaded and saved to an SD card.
Saving Data Logs for the FLEXmax Charge Controller
Figure 168 Uploading and Saving a Data Log for the FM Charge Controller
To create a data log for the FLEXmax Charge Controller:
1. Access the Main Menu as shown in Figure 71.
2. Select the Device Data Logs menu.
3. Select FLEXmax Charge Controller menu.
4. Select Upload and Save Data Log on the FM Charge
Controller Data Log menu.
5. Select one of the two options.
 Press to give the new data log a unique name. Or
 Press to save the data log over the name that is
highlighted on the list.
6. After saving the data log is complete, press to
return to the
Upload and Save Data Log screen.
To save a new data log over the name highlighted on the list:
1. Use the control wheel to scroll through the list.
2. When the name to be replaced is highlighted, press .
3. Wait for the message confirming that the profile has been
saved to the SD card.
4. Press to return to the Upload and Save Data
Log menu.
To create a new name for the data log (up to 8 characters
maximum):
1. Use the control wheel to scroll through the available
characters.
2. Use <> or <> to move to the desired character location.
3. Press to erase the character that is highlighted.
4. Press to save the new data log on the SD card.
4. Press to return to the Upload and Save
Data Log menu.
Returns to the Upload and
Save Data Log screen.
Returns to the Upload and
Save Data Log screen.
See the sample data log on page 141.