HP XP P9500 Storage - Manual (Page 409)

To display the monitor operation format
/opt/DynamicLinkManager/bin/dlnkmgr monitor -help
Parameters
Note
If the number of paths to be displayed by the monitor operation is 500 or
more, the execution of the monitor operation might be delayed as
follows:
¢
The time displayed in StartTime might be later than the time the
monitor operation is actually executed.
When the number of paths is approximately 2000, the time delay will
be about seven seconds, and when it is 4000, 20 seconds.
¢
If you specify a shorter time value than the recommended value listed
in Table 6-21 Recommended values for the -intvl parameter when
there are 500 or more paths on page 6-69 for the -intvl
parameter, the time interval of the monitor operation might be
several seconds to 20 seconds late for the value specified in the -
intvl parameter.
If the number of paths is 500 or more, specify an appropriate value
for the -intvl parameter based on the values listed in Table 6-21
Recommended values for the -intvl parameter when there are 500
or more paths on page 6-69 . However, when any of the following
operations is performed concurrently with the monitor operation,
even if you specify a value listed in the following table, the time
interval of the monitor operation might be a few seconds late.
- The view operation
- Path health checking
- Automatic failback
Table 6-21 Recommended values for the -intvl parameter when there
are 500 or more paths
Number of paths
(approximate)
Recommended value specified for the -intvl
parameter (seconds)
500 3 or more
1000 5 or more
2000 10 or more
4000 30 or more
To display I/O information for each HBA port
-hbaid HBA-port-ID
Command Reference
6-69
Hitachi Dynamic Link Manager User Guide for Solaris ®