HP XP P9500 Storage - Manual (Page 251)

The following shows an example of executing the command to delete SVM
local volume d0.
host1# metaclear d0
When using a shared diskset
1
.
Delete the shared volume.
The following shows an example of executing the command.
When not using Sun Cluster:
host1# umount /diskset1
host1# metaclear -s diskset1 d1
When using Sun Cluster:
host1# umount /global/diskset1/d1
host1# metaclear -s diskset1 d1
2
.
Delete the disk from the shared diskset.
The following shows an example of executing the command.
When not using Sun Cluster:
host1# metaset -s diskset1 -d -f c5t1d2 c5t1d3
When using Sun Cluster:
host1# metaset -s diskset1 -d -f /dev/did/dsk/d10 /dev/did/
dsk/d11
3
.
Delete the shared diskset.
The following shows an example of executing the command.
host1# metaset -s diskset1 -d -f -h host1 host2
Removing HDLM
Removing HDLM from the Local Boot Disk Environment
When you remove HDLM, if the KAPL09019-E or KAPL09020-E message is
output, follow the procedure described in Removing Hitachi Network
Objectplaza Trace Library (HNTRLib2) on page 3-194 to remove HNTRLib2.
However, if the KAPL09026-I message is output, since a program other than
HDLM is using Hitachi Network Objectplaza Trace Library (HNTRLib2), only
HDLM will be removed.
Note
¢
When removing HDLM on a host where a Device Manager Agent 5.0 or
later is installed, do not execute any of the following commands of
Device Manager Agent during removal. Also, do not remove HDLM
while executing any of the following Device Manager Agent
commands:
hbsasrv, HiScan, hdvmagt_account, hdvmagt_schedule, hldutil,
TIC
Creating an HDLM Environment
3-185
Hitachi Dynamic Link Manager User Guide for Solaris ®