HP XP P9500 Storage - Manual (Page 115)

To boot at the ok prompt, execute the following command:
boot boot-device kernel/sparcv9/unix other-boot-options
Set Up the /etc/system File
HDLM uses a maximum of 8 KB of the stack for the kernel thread. Add the
usage of HDLM to this maximum value, specify that total value as the stack
size for the kernel thread, and then install HDLM. In Solaris 10 or Solaris 11,
default_stksize has priority over lwp_default_stksize. Therefore, if
default_stksize is specified in /etc/system, add 8 KB to the value
specified in default_stksize. If the documentation for the volume manager
or file systems that use HDLM devices specify that the stack size for the
kernel thread is to be expanded, the value mentioned in the documentation
must be also added to the stack size.
The procedure for increasing the stack size of the kernel thread from the
default size in a system with a 64-bit kernel is as follows:
In Solaris 8 or Solaris 9
Add set lwp_default_stksize=0x6000 to /etc/system, and then restart
the host.
In Solaris 10 or Solaris 11
Add one of the following parameters to /etc/system, and then restart the
host:
¢
set lwp_default_stksize=0x8000
¢
set default_stksize=0x8000
The default_stksize parameter takes precedence when both
parameters are specified.
Set Up the /etc/syslog.conf or /etc/rsyslog.conf File
The dlmsetconf utility and the DLMgetras utility for collecting HDLM error
information output messages to syslog. See the /etc/syslog.conf or /etc/
rsyslog.conf file (system log configuration definition file), and then check if
it is set so that messages with a level of "Error" or higher are to be output.
Make sure that the /etc/syslog.conf or /etc/rsyslog.conf file contains
the following configuration entry. We recommend setting the output
destination for *.err in the /etc/syslog.conf or /etc/rsyslog.conf file to
the default /var/adm/messages directory.
*.err;kern.debug;daemon.notice;mail.crit; /var/adm/messages
When you collect audit log data, we recommend that you use any of the
extended facilities (local0 to local7) as the exclusive output destination for
the data. We also recommend that you specify info as the severity level for
the extended facility. This example shows how to specify the recommended
settings in the /etc/syslog.conf or /etc/rsyslog.conf file:
Creating an HDLM Environment
3-49
Hitachi Dynamic Link Manager User Guide for Solaris ®