HP XP P9500 Storage User Manual
Page 354
the view operation to find the current AutoPATH_ID of the target path,
before executing the online operation.
Example
The following example shows how to place online the paths connected
to the CHA port 0A. In this example, a path whose AutoPATH_ID is
000002 is connected to the target CHA port:
# /opt/DynamicLinkManager/bin/dlnkmgr online -cha -pathid
000002
KAPL01057-I All the paths which pass the specified CHA port
will be changed to the Online status. Is this OK? [y/n]:y
KAPL01061-I 2 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
#
-chaid CHA-port-ID
Use this parameter to place online, at one time, all paths that pass
through a specific CHA port. The command will place online all paths
connected to the CHA port that has the specified CHA-port-ID. To display
the CHA port IDs, execute the following view operation:
# /opt/DynamicLinkManager/bin/dlnkmgr view -cha
For details, see
To display CHA port information on page 6-65
in
.
Example
The following example shows how to place online all paths connected
to the CHA port whose CHA-port-ID is 00001.
# /opt/DynamicLinkManager/bin/dlnkmgr offline -chaid 00001
KAPL01104-I All the paths which pass the specified CHA port
will be changed to the Online status. Is this OK? [y/n]:y
KAPL01061-I 15 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
#
-pathid AutoPATH_ID
Use this parameter to place a single path online.
Specify the current AutoPATH_ID of the target path, which is displayed by
using the view operation. For details on the view operation, see
(Displays Information) on page 6-32
. Leading zeros can be omitted
(000001 and 1 indicate the same AutoPATH_ID). Therefore, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
AutoPATH_IDs are re-assigned every time the host is restarted. When you
want to add a new LU without restarting the host, AutoPATH_IDs are re-
assigned to each path of the LU when you execute the dlmcfgmgr utility.
Always make sure that you execute the view operation to find the current
AutoPATH_ID of the target path, before executing the online operation.
-device SCSI-device-name
6-14
Command Reference
Hitachi Dynamic Link Manager User Guide for Solaris
®