HP XP P9500 Storage - Manual (Page 329)

switches, cables between hosts and the storage system devices, and the
HBA driver.
6
.
Set up switches and other devices so that the logical units in the
destination storage system are recognized by the OS.
# cfgadm -c configure ap_id
For the value to be specified for ap_id, see the listing of hardware
information displayed by the cfgadm -al command.
The following shows an example of executing the command.
# cfgadm -al
Ap_Id Type Receptacle
Occupant Cond
system:slot0 cpu/mem connected
configured ok
system:slot1 sbus-upa connected
configured ok
7
.
Execute the format command, and confirm that the new logical units
recognized by the OS are displayed. Also confirm that a disk label is
specified for the logical units.
# format
If you do not use a storage-system-migration definition file, go to step 9.
8
.
Execute the dlmsetconf utility as shown below to verify the integrity of
the storage-system-migration definition file.
# /opt/DynamicLinkManager/bin/dlmsetconf -c
If there are problems with the storage-system-migration definition file,
re-create the file, and then continue the procedure from step 9.
9
.
Execute the dlmsetconf utility as shown below to update configuration
definition files.
# /opt/DynamicLinkManager/bin/dlmsetconf -t
If a storage-system-migration definition file exists, a response message is
output asking you what to do about any LUs not in the storage-system-
migration definition file. Respond by entering y or n.
y: The logical unit that does not exist in the storage-system-migration
definition file inherits the logical device name, under the condition that
the host logical unit number of the migration source is the same as that
of the migration destination. (The logical device name migration is
executed under the condition that is the same as the one in which the
storage-system-migration definition file does not exist.)
n: The logical unit that does not exist in the storage-system-migration
definition file does not inherit the logical device name. A new logical
device name is created.
10
.
If the new logical units recognized by the OS include units to be excluded
from HDLM management, first edit the HDLM driver unconfiguration
definition file (/opt/DynamicLinkManager/config/dlmfdrv.unconf).
HDLM Operation
4-67
Hitachi Dynamic Link Manager User Guide for Solaris ®